Casting
I started casting when you could not find anthing. I can buy a 5 gallon pale of wheel weights at a tire store for 10 and somtimes a dozen donoughts for the guys too. That makes a lot of bullets. Its a little up front money but has saved me a lot over the years. Just my two cents.
Any body use one and how do i get the cord through my safe? Safe does have a small hole drilled through the top plate on top but not through the second plate. Any info will help.
Thanks
Adam
On hot days i carry a comander 1911 with a leather blackhawk holster with extra mag built in the holster. One days i wear leathers i carry a 38 in my front pocket. Always have a passenger when ridding also and the 1911 dosent bother her.
I stop a diffrent alleys and ask, usuall a buck or two. I have found out in the past it works better if you say they are for art projects. I know a couple of places are anti gun and the art excuse wworks well and somtimes there free. Shipping is just so much.
Mossburg 500 with diffrent stock options depending where I might be. Have side saddle for more rounds and also a bandolla that i bought years ago from a garage sale that holds 75 rnds. Also have pisols. In MI though so no big storms.
As many as I can afford without bringing attention from the wife. Though a 22, 357,44 and a 500 covers a lot in my opinion. I have just as much fun shooting my rough rider (100 gun) as I do my S&W 500.
I prefer a hammer to target practice with. In the summer I probably shot about 25-50 rds a week with my 605. I have just taught my self to put my thumb over the hammer when I draw. Never have a problem. Just my 2 cents.
I have used it in 44, 45LC and have had good luck. Though the manfacture did say somthing about not using it in mag loads and cold weather I think. I have never had a problem in Michigan in the winter but just wanted to mention it.
I have one that I use for 38/357's but the add said it works great for 9mm too. Its .358 and the cast for 9mm should be .356. Was wondering if anybody has used this for a 9mm? Or if it would work if I orderd the sizer in.356. Its the 105 gr SWC. I just dont want to led my barrel.
Thanks
Adam
I go to a chain shop and offer a 20 for lunch for a 5 gallon bucket. There not suposed to sell it (becasue they have a bulk buyer) but i never have a problem getting my bucket when needed. Good luck, you can save a lot and it seems my brass last longer due to the lower presure.
Quarter passing
Those were my thoughts but a quarter will not pass and it is also not stamped a light weight on the barrel. That’s where I keep getting confused.
Thanks
Adam
I have a 870 wing master barrel that was taken of a gun back in the middle 90’s. I wanted to sell this but I want to make sure what it is before I sell it. I don’t have any 870’s to try it out on. The only markings that stand out to me is a star before the 20ga stamping on the barrel. The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.