Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1911 22 conversion assembly

Discussion in 'Gunsmithing and Repairs' started by Ron Brooks, Sep 1, 2006.

Thread Status:
Not open for further replies.
  1. Ron Brooks

    Ron Brooks Member

    Joined:
    Jun 25, 2006
    Messages:
    94
    Location:
    Panhandle of Texas
    I have a Colt 1911 22 Conversion that I bought years ago. I haven't used it in over 10 years and would like to use it again, but dang if I can quite remember where to put the stamped ejector piece. :-( I have searched this site as well as Google and Yahoo and can't find any help. How about it?

    Thanks,

    Ron
     
  2. Geno
    • Contributing Member

    Geno Member

    Joined:
    Jun 11, 2005
    Messages:
    15,266
    Just put it in a box...

    Then, address it to me. Send it postage due. It's the least I can contribute for your troubles.

    Doc2005
     
  3. Ron Brooks

    Ron Brooks Member

    Joined:
    Jun 25, 2006
    Messages:
    94
    Location:
    Panhandle of Texas
    uh-huh :) I really appreciate the offer and will sure keep it in mind. :D
     
  4. BEARMAN

    BEARMAN Member

    Joined:
    Feb 24, 2003
    Messages:
    395
    Location:
    CANADA
  5. Mac Attack

    Mac Attack Member

    Joined:
    May 29, 2003
    Messages:
    751
    Location:
    Georgia
    The ejector slides onto a slot on the left side of the barrel (viewed with the slide top facing the ground). The the ejector slides into a slot cut into the slide. The key to dropping in the ejector is to first fit it to the barrell and then move the barrel forward towards the bushing unti the ejector drops down. Then push the barrel back towards the breach and the ejector will slide right into the slot in the frame. It's really easy and will take less than a second to do.
     
  6. Ron Brooks

    Ron Brooks Member

    Joined:
    Jun 25, 2006
    Messages:
    94
    Location:
    Panhandle of Texas
    Bearman,

    Thanks for the URL to the manual. It was a great help. I saved it to my harddrive and printed it out.

    Mac Attack,

    I really apprecaite the tip on installing the ejector. It really helped.

    What was funny was 10 years ago I could assemble the thing like a champ. Now here I was trying to use it and coming up with the ejector and going "Now how does this go in?"

    Thanks again, very much appreciated.

    Ron
     
Thread Status:
Not open for further replies.

Share This Page