I have a 1911 that was worked on in the 1970's.
The rails on the frame were tightened up so I suspect this is the cause of the off center strikes.
The strikes are more than half the firing pin dia off from center.
Kart fit barrel.
Is there anything I could do to re-center the firing pin hit zone (for lack of a better term)?
Or do I have to re-fit a barrel?
Even better is there nothing to worry about?
[/url][/IMG]
The rails on the frame were tightened up so I suspect this is the cause of the off center strikes.
The strikes are more than half the firing pin dia off from center.
Kart fit barrel.
Is there anything I could do to re-center the firing pin hit zone (for lack of a better term)?
Or do I have to re-fit a barrel?
Even better is there nothing to worry about?
Last edited: