Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

243 Winchester with IMR-7828

Discussion in 'Handloading and Reloading' started by kalbo, Jan 8, 2009.

Thread Status:
Not open for further replies.
  1. kalbo

    kalbo Member

    Joined:
    Dec 24, 2008
    Messages:
    15
    Has anyone loaded 243 Winchester with 100 grain bullets and IMR-7828 powder? I have been using IMR-4350 with good results but was mulling over trying this.
     
  2. Gary Brintzenhofe

    Gary Brintzenhofe Member

    Joined:
    Jan 7, 2009
    Messages:
    20
    Location:
    Pa.
    I always used imr-4895 100gr. spr.BTSP 100 yards three shot touching almost hole for hole. IMR-7828 didn't do as good.
     
  3. NCsmitty

    NCsmitty Member

    Joined:
    Jun 29, 2008
    Messages:
    5,325
    Location:
    North Carolina
    IMR-7828 powder will work but it's real slow burning and the Max load is a compressed load.
    Go to www.hodgdon.com and check it out.
    You'll be hard pressed to better IMR4350 or H4350 but some of the new powders do look promising.
    If you already have some IMR7828, it won't hurt to try it.

    NCsmitty
     
  4. JimKirk

    JimKirk Member

    Joined:
    Nov 23, 2008
    Messages:
    2,844
    Location:
    Nicholls,GA South Georgia
    Nosler Manual #3

    This is a load out of Nosler Manual #3 :
    100gr.
    IMR 7828 43.5 gr. 3000 fps
    IMR 7828 47.5 gr. 3250 fps

    I am getting 3215 fps out of a Rem 700 22" barrel with 47.5 gr.
    Pact Chrono 80* temp

    Jimmy K
    CAUTION: The following post includes loading data beyond currently published maximums for this cartridge. USE AT YOUR OWN RISK. Neither the writer, The High Road, nor the staff of THR assume any liability for any damage or injury resulting from use of this information.
     
    Last edited: Jan 9, 2009
  5. Galil5.56

    Galil5.56 Member

    Joined:
    Dec 20, 2007
    Messages:
    1,092
    Dang, that's SNAPPY!
     
  6. JimKirk

    JimKirk Member

    Joined:
    Nov 23, 2008
    Messages:
    2,844
    Location:
    Nicholls,GA South Georgia
    Yes it is ! The best I could get out of IMR 4831 was about 3035 fps ...Reloader 19 was in the same ball park ....until I tried IMR 7828....I had the same idea that most of you had ....7828 was too slow for 100gr 243 bullets.....WRONG! I also get good Velocity out of my 25/06 with 7828 too!
    The 243 load is from Nosler # 3 Manual. I may have a fast Rifle also, I could not get that figure out of a Ruger S.S. 243 22" barrel.

    Jimmy K
     
  7. tango2echo

    tango2echo Member

    Joined:
    Dec 14, 2008
    Messages:
    811
    I have had similar experiences with 7828 as what JimKirk has said. One of my .243's has a 24" barrel and I usually get 3270fps with 47grs of powder and the 100 BTSP's. However, it does not shoot nearly as well as 4895 does in any of my .243's where I can get under .5MOA with two of them.
     
  8. Galil5.56

    Galil5.56 Member

    Joined:
    Dec 20, 2007
    Messages:
    1,092
    I saw the current 7828 data at the Nosler website was cut to 45.5 grains for 100 grain Partitions. That velocity really is amazing for a 100 grain bullet in .243, esp for 22", as is Tango's 24" barrel results; simply amazing. My .243 is a heavy varmint rig, but if I used it for deer I would definitely look into 7828/100 grain bullets... Maybe I will do some open field sniping. :)
     
  9. tango2echo

    tango2echo Member

    Joined:
    Dec 14, 2008
    Messages:
    811
    Shot a 140lb doe at 327 lasered yards with the load I posted above. Bullet impacted 3.5" below POA. Tiny entrance wound. Fist sized exit wound. Heart/Lungs were mush. Eight ribs broken. Deer dropped dead where she stood. I may cut this load back some as I see some of the most recent manuals list a lower maximum. I was unaware of the change untill this post.

    T2E
     
  10. JimKirk

    JimKirk Member

    Joined:
    Nov 23, 2008
    Messages:
    2,844
    Location:
    Nicholls,GA South Georgia
    Gali556
    I think you think I am yanking your chain, but I can get the full 3250 fps with a Nosler 95gr Ballistic tip with a 22" barrel. Like I said the gun may have a fast barrel. By the way I get about 1" groups @ 100yds with the 7828 ...I get slighty better with IMR 4831 maybe 3/4" - 7/8" either will kill deer very dead. If you use 100 gr Nosler partion, which I can't get to shoot any better than 1 1/2" groups, I think you would have a bigger deer killer.

    Jimmy K
     
  11. JimKirk

    JimKirk Member

    Joined:
    Nov 23, 2008
    Messages:
    2,844
    Location:
    Nicholls,GA South Georgia
    Warning!

    I should post that this load shows no over pressure signs in my rifle, your rifle may be unsafe with this load and I did state that it was a published load in Nosler #3 Manual which had to be ok with Nosler lawyers at the time it was published, it may not be ok with Nolser or who ever makes IMR 7628 (NOW) lawyers. consult your own personal lawyer before using this load.

    Jimmy K:)
     
  12. GooseGestapo

    GooseGestapo Member

    Joined:
    Jan 6, 2003
    Messages:
    3,274
    Location:
    W.GA
    I've not used the IMR7828 in the .243. However, the RL22 gave excellent accuracy with the Nosler Max and most accurate load in the #4 manual. 42.5gr. I got over 3,100fps with both 95gr Nosler BT and 100gr Hornady BTSpt.

    However, bullet performance on game is better when mv's are about 2,800-2,900fps..... Fewer close range "blow-ups".

    I too, have gotten very good accuracy from H4895 in the .243.
     
  13. PCJim

    PCJim Member

    Joined:
    Jul 15, 2008
    Messages:
    52
    If you have IMR 4350

    I'd stick with it. That is the only powder I've used for 100gr bullets in .243.

    This is from Saturday with my reloads (100gr Hornady SPBT, 40.0gr IMR-4350) in a LSA-55. A three shot group at .89 inches using a solid V support under the forearm and buttstock on my shoulder. I would really like to know what the rifle's capabilities would be with a lead sled as I am no precision shooter....
     

    Attached Files:

Thread Status:
Not open for further replies.

Share This Page