lvcat2004
Member
I'm relatively new to reloading, and new to 454 reloading and have a question. I was just setting up my dies and seated the bullet on unprimed case.
left is my handload, right is factory ammo. overall length is supposed to be 1.745 and I'm around 1.748.
It looks like the the left one is bigger but that's just my photo.
I think you can see that there is a bit of a bulge where the bullet is and also slightly at the bottom on my handload, but not the factory load.
I did not resize my brass as it was once fired and not much different, and the overally size looks good, but this slight bulge is bugging me.
Advice please?
left is my handload, right is factory ammo. overall length is supposed to be 1.745 and I'm around 1.748.
It looks like the the left one is bigger but that's just my photo.
I think you can see that there is a bit of a bulge where the bullet is and also slightly at the bottom on my handload, but not the factory load.
I did not resize my brass as it was once fired and not much different, and the overally size looks good, but this slight bulge is bugging me.
Advice please?