642 Cleaning & Misfire
Hi Folks,
I'm new to this, read a lot in the forums and internet, decided on a 642-2 CT after I got my concealed weapons permit recently. So far I like it a lot. Got an array of holsters: pocket, belt, shoulder, and have been carrying daily to get familiar.
Been to the range a few times and put 300 rounds of 38 158gr FMJ and another 100 38 + P 158gr TMJ through it. Very accurate, with and without the laser at 7 yards. Cleaned it once with Hoppe's 9 and after reading all the posts have determined that is a no no. What I have picked up reading the post's is:
No ammonia!
Use Hoppe's Elite Cleaner, Hoppe's Elite Bore Gel, Break-Free CLP, and Gun Scrubber. I've seen a few Gun Scrubber products, is synthetic Safe Cleaner and Solvent/Degreaser ok?
Are all of these ok?
On my last 50 rounds of FIOCCHI 38sp 158 FMJ I had 2 misfires
. When I compare the firing pin indentation on the misfires to the successful fires, there is a definate difference, a smaller indentation. Can this happen if I hesitate in the trigger pull? I read a similar post and was wondering if you guys have seen this?
Time for a trip back to the factory?
Thanks