josephbw
Member
I received my tumbler yesterday and so far I've run 2 loads of brass through it, but I'm having a couple of issues. The first issue was that the large pulley was bent and makes the motor shake and wobble. I tried to straighten it, but it wouldn't yield to hand pressure.
What method do you guys use to separate the SS pins from the brass? I've been reaching into the barrel and pulling out the brass, and manually separating pins and brass, but that's a time consuming pain in the butt. :banghead:
One thing I hadn't seen anyone talk about when they extolled the virtues of this machine, was the surface tension adhering the pins to the rubber liner of the drum. If I could defeat this issue it would make things a lot easier.
BTW, it cleans the brass thoroughly, and makes it look like new.
What method do you guys use to separate the SS pins from the brass? I've been reaching into the barrel and pulling out the brass, and manually separating pins and brass, but that's a time consuming pain in the butt. :banghead:
One thing I hadn't seen anyone talk about when they extolled the virtues of this machine, was the surface tension adhering the pins to the rubber liner of the drum. If I could defeat this issue it would make things a lot easier.
BTW, it cleans the brass thoroughly, and makes it look like new.