T
thump_rrr
Latest activity Postings Images About
-
-
Tthump_rrr replied to the thread What have you done in the reloading room today.We are now in Gardiner Mo. near the North entrance of Yellowstone. Just over 1500 miles so far. Added Idaho, Wyoming and Montana to my...
-
Tthump_rrr reacted to Ray P's post in the thread What have you done in the reloading room today with
Like.
Tonight I finally swapped out brass in the vibratory tumbler. The heavily tarnished stuff came out all right. Current batch going in is... -
TNo pictures, and not today either :) but Sunday morning. My dads Remington model 870 12 ga. My buddy and I did a round of sporting...
-
Tthump_rrr replied to the thread What have you done in the reloading room today.I’m on a 2 week vacation visiting Vegas, Grand Tetons, Yellowstone ,Moab, and Arches National Parks. I miss not being able to reload so...
-
TShot my CZ 457 Varmint today. Played around with some SK Semi Auto and some SK Standard Plus. The Semi Auto shoots better in this gun...
-
Tthump_rrr replied to the thread What did you shoot today?.A little of this and a little of that.
-
Tthump_rrr replied to the thread Have you purchased anything gun related in the last three days?.Where did you order it from? I have a 6” Stainless Dan Wesson 744HV that I’d like to get an 8” barrel for. This week I picked up a set...
-
Tthump_rrr reacted to stonebuster's post in the thread Have you purchased anything gun related in the last three days? with Like.
The CZ/USA 6VH barrel arrived yesterday I had ordered last week. Put it on the DW Model 15-2 357 last night.
-
TSounds like you like to make a big deal about nothing. The economy sucks. Inflation is killing small businesses everywhere. Your only...
-
Tthump_rrr reacted to AJC1's post in the thread What have you done in the reloading room today with Like.
Well I loaded the 60 45c that were in the tumbler, no major dust on the cases to speak of. The steel table was coated, blew that out...
-
Tthump_rrr reacted to GeoDudeFlorida's post in the thread What have you done in the reloading room today with Like.
Have you tried Tractor Supply? I can usually find Agra-Grit for less than $1/#. It’s a very good product and no additive...
-
Tthump_rrr replied to the thread What have you done in the reloading room today.Been very busy at work but have a competition this weekend. Prepared 400 cases. Over the last couple of days I loaded 100 rounds of...
-
TResolution is 1 kernel of Varget. I confirmed both accuracy and resolution by letting it auto trickle to a stop, then remove one kernel...
-
Tthump_rrr replied to the thread Scope Height vs. Cheek Weld ?.Most of mine use medium (1") rings but if you add lens covers that may need to be upped to high. Most of mine don't have lens covers on...
-
Tthump_rrr replied to the thread Scope Height vs. Cheek Weld ?.For the most part you will usually need some form of cheek riser with an objective diameter of 50 or 56mm which are the most commonly...
-
-
-
Loading…
-
Loading…
-
Loading…
