Advantage Arms Glock detail strip

[matai]

Hey, anybody know how to detail strip an Advantage Arms Glock .22lr conversion slide? I've emailed AA but haven't heard back.

After 20 or 30 thousand rounds it's getting gritty inside.

Thanks!

 

[Hk Dan]

It's straight forward, just make sure you get the little ejector tab lined up properly when ya reassemble.

 

[gofastman]

It strips just like a glock with the exception of the extractor retainer pin, watch out for the tiny spring that places tension on the extractor too.
that spring can bind up upon reinstallation so watch out for that.


this may help you too.
http://glocktalk.com/forums/showthread.php?t=1251184

 

[matai]

Thank for all the help.

One more question, how do you guys clean out the hole where the ejector goes in?? I can shoot CLP up in it and it comes out super dirty. I'll also clean the extractor, put it in and it will come out dirty.

Any ideas?

 

[gofastman]

I would think an aerosol gun cleaner like Gun Scrubber would do the trick.

I bet you could also blast it with CLP and wait a few hours for it so loosen stuff up then repeat until its clean. CLP works great, but it needs more dwell time than other cleaners.