Anyone here own a T/C Seneca ? Need stock info.

[BADUNAME30]

This is the forend of a T/C Seneca stock i'm thinkin o' buyin.
Is this nose gaurd screw hole 'blown' thru ?

 

[Curator]

Jim,

Your forearm seems correct. The large hole nearest the end is for a large-headed screw that retains the forearm cap. The smaller hole to the rear of the other is for the screw that retains the ramrod entry-pipe. If you can find an "exploded view" online somewhere it will become obvious.

 

[BADUNAME30]

Thanx Curator.
Lookin at my pics and then these pics in the link below, of a Seneca nose gaurd, it looks like those holes are only there to hold the gaurd to the stock. As you can see, the "ramrod entry-pipe " is built into the gaurd.This is why i question that larger hole.

http://www.ebay.com/itm/ws/eBayISAP...6676&item=110976606676&lgeo=1&vectorid=229466

 

[Curator]

Jim,

The forward hole on my two Senecas have a large (7/16) flat-head screw that goes into the nose cap. The rear screw is much smaller (1/4") head. The nose caps/entry pipes on my Senecas do look slightly different than the one on Ebay. That may be one form a Patriot pistol. I am not sure if they are interchangeable with the Seneca rifle.

 

[BADUNAME30]

Thanx Curator, i'm learnin that i don't yet know enough about this gun to attempt this build.