I have been using the APS bench mount priming tool when priming larger batches due to my arthritis. Today I primed about 400 9mm cases and then the primer plug came out of alignment. I took the top cap off removed the plug put the top cap back on reseated the plug with the handle down and it worked for mabe 5 cases and jammed again. So I did the whole process over again and it jammed again after a couple of cases. I am using both the small and large sleeves on my shell holder. After working for 400 I can't figure out what is wrong.
Help is appreceated!
Thank you
Help is appreceated!
Thank you