Anyone familiar enough with the AR-10 format and or DPMS 308 firearms to tell me if having a loose bolt ejector pin is standard? Not only was the one in question about 0.045" to narrow in diameter but was 0.474" long. Which is too short. Fabricated a new thicker, longer one from hardened steel drill shank , 0.54"long x 0.124 dia. up from 0.474 x 0.118".
Uppers/ lowers were matched set but from different supplier than BCG.
It is like the AR-15 BCG with serrations on the side. The 308 does not need assist in closing the bolt home. I have read serrated bolts should not be used in higher caliber firearms. So ordered a new smooth Ni-Bo coated BCG so we'll see.
Uppers/ lowers were matched set but from different supplier than BCG.
It is like the AR-15 BCG with serrations on the side. The 308 does not need assist in closing the bolt home. I have read serrated bolts should not be used in higher caliber firearms. So ordered a new smooth Ni-Bo coated BCG so we'll see.