AR Guys. I have a dumb question.

[DogBonz]

How, in the name of everything that’s holly, do you remove the roll pins to disassemble the trigger guard? Do I just tap then out with a punch? I tried that with the rear one, and it seemed that that little pin should not require that much force, so I stopped before I damaged something.

Next, the front one; how the does that thing come out of there?

I am total lost here, I bought the Magpul funky trigger guard to give me fingers a bit more room (mostly because I think it looks cool), and I can’t figure out how to get the old one out to get the new one in.

As always, your assistance is much appreciated.

Thanks,


Fred

 

[browningguy]

See paragraph 4 here:
http://www.ar15.com/forums/topic.html?b=3&f=4&t=226782

You do need the correct size punch, should come right out, make sure you support the receiver.

 

[DogBonz]

Browning guy

thanks, I can't access that site now, but I will when I get home.

-Fred

 

[ARperson]

Check to see that the roll pin is on the right side of the trigger guard. I was a dolt and installed my wifes trigger gaurd in backwards. One side uses a roll pin, the other does not.