At a loss on how to fix.

[nulook45]

On the marlin If it is firing reliably now but fails to extract live rounds that is a common problem , a new extractor is needed . You might also find help over at www.rimfirecentral.com they have a entire section on ways to fix Marlin rifles and others as well good luck

 

[Kuyong_Chuin]

On the marlin If it is firing reliably now but fails to extract live rounds that is a common problem , a new extractor is needed . You might also find help over at www.rimfirecentral.com they have a entire section on ways to fix Marlin rifles and others as well good luck

It still not firing reliably, though it is doing better with the Winchester rounds than the Federal rounds. I do not have any of my preferred CCI mini mags or stingers at the moment to try.

On the M44 I just came in from checking it and the shim I put in it was not thick enough. It was also made of thin card stock so I think I compressed it down from the starting 0.12 of an inch that it started with but it was just to see if it would work in theory. I replaced the shim with one made of a thin plastic that is 0.35 of an inch thick and it moved it enough to get some adjustments in the scope now. I rounded off my allen wrench and can not find the one that came with the mount right now so it is not as tight as it should be. When I get back to town I'll pick up a metric set of wrenches and see if I can get a metal shim to replace the plastic one that is there now. It is now aiming at the same point as the iron sights which was shooting high but centered and I centered the adjustments on the scope before lining it up so I should be able to get it sighted in once I have the new shim and everything locked back down.