I did a little searching but the write ups I found for filling out an eform 1 are talking about filling one out for an SBR. I'm working on filling one out to make a .22 suppressor and have a few questions.
1. When adding a line item I am listing my trust as the manufacture because I am the one making it, but when I do it gives a prompt that this is an unknown manufacture. It ends up giving me three warnings; unknown item, unknown model and unknown manufacture. Am I doing something wrong, or is this normal for filling out a form 1? My trust already has an approved SBR stamp and suppressor stamp from paper form 1 and form 4. Should my trust show up when I enter it in as the manufacture?
2. Electronic documents: What documents do I need to upload? I know at a minimum I need to upload a copy of my trust, what else do I need? Do I need to have a drawing of my planned suppressor design?
Anything else I should keep in mind while filling it out?
Thanks in advance!
1. When adding a line item I am listing my trust as the manufacture because I am the one making it, but when I do it gives a prompt that this is an unknown manufacture. It ends up giving me three warnings; unknown item, unknown model and unknown manufacture. Am I doing something wrong, or is this normal for filling out a form 1? My trust already has an approved SBR stamp and suppressor stamp from paper form 1 and form 4. Should my trust show up when I enter it in as the manufacture?
2. Electronic documents: What documents do I need to upload? I know at a minimum I need to upload a copy of my trust, what else do I need? Do I need to have a drawing of my planned suppressor design?
Anything else I should keep in mind while filling it out?
Thanks in advance!