I am getting ready to undertake a little project.
I ordered a Hogue stock for my 10/22. I want to bed it and float it to see what accuracy I can gain from an otherwise factory rifle.
Questions:
1. Will a standard stock cutting tool cut the synthetic material when I float it?
2. I know there are bedding materials out there for synethics. Any recommendations?
3. General comments or tips?
I am considering this a practice run and if everything works out, I may consider duplicating the procedures on my big rifles too.
Thanks.
I ordered a Hogue stock for my 10/22. I want to bed it and float it to see what accuracy I can gain from an otherwise factory rifle.
Questions:
1. Will a standard stock cutting tool cut the synthetic material when I float it?
2. I know there are bedding materials out there for synethics. Any recommendations?
3. General comments or tips?
I am considering this a practice run and if everything works out, I may consider duplicating the procedures on my big rifles too.
Thanks.