Bending Glock trigger guard?

[Dalerj]

I am thinking about a glock 17. The problem is my trigger finger has a bend (sideways) in the second joint. This causes the tip of my finger to drag on the inside of the glock trigger guard. Would it be possible to bow out the bottom of the guard 1/4 inch using heat? What temp does the glock plastic get soft enough to bend? Thanks, Dalerj

 

[krs]

Dunno, but there was a guy here with demos of stippling in the plastic done with a 35 watt soldering iron. At least I think he said it was 35 watts.