Bersa Thunder Grips

[Mr_Flintstone]

Is there a manufacturer of thin aluminum or composite grips for the Bersa Thunder 380; like the ones made by VZ or LOK for the CZ 75? The factory grips seem to be much wider than they need to be because of the thumb rests on the grips. Although the frames are about the same on the Thunder 380 and Makarov, the Thunder 380 grips are about 1/4 inch wider.

 

[bannockburn]

A quick Google search turned up some Bersa factory walnut grips on Midway for $36.99, wood grips by siamgear on Ebay for $42.99, and some carbon fiber ones for $79.00 from schn_bria also on Ebay. Don't know how thick any of these grips might be but you can always contact the seller to see if they will measure them for you.

 

[Mr_Flintstone]

A quick Google search turned up some Bersa factory walnut grips on Midway for $36.99, wood grips by siamgear on Ebay for $42.99, and some carbon fiber ones for $79.00 from schn_bria also on Ebay. Don't know how thick any of these grips might be but you can always contact the seller to see if they will measure them for you.

The factory walnut grips are actually a little thicker than the plastic. I'll check on the carbon fiber.

 

[kokapelli]

too bad the Thunder CC grips won't fit since they are a lot thinner.