Browning Buckmark firng pin block assembly

[brucecal]

In field stripping my Browning Buckmark, I finally succeeded in bending the guide rod in the firing pin block assembly. I straightened it out (a bit) but it still looks a little bent.
In researching parts online I can not find any place that sell this assembly. I do not see a way to take the assembly apart to just replace the guide rod.
Does anyone know where this assembly can be purchased.

Thanks for any help.
Bruce in Houston Texas

 

[gb6491]

Bruce,
On the new style (2001 to date) Buck Mark slide, the recoil spring guide rod is held in the plastic trigger housing by tension of the recoil spring. There is a small clip on the free end of the rod; if you remove it (be careful) the spring can be released and the rod removed from the housing. The housing itself is a friction fit in the slide.
Parts are available from:
Browning - http://www.browning.com/customerservice/partsandservice/index.asp
Brownells - http://www.brownells.com/.aspx/pid=0/sid=366/schematicsdetail/Buck_Mark
MGW - http://midwestgunworks.com/page/mgwi/CTGY/browning-buckmark-parts

Regards,
Greg

BTW: Welcome to the forums