1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bulldog Cylinder latch

Discussion in 'Gunsmithing and Repairs' started by Edward429451, May 5, 2003.

Thread Status:
Not open for further replies.
  1. Edward429451

    Edward429451 member

    Dec 24, 2002
    Colorado Springs Colorado
    My CA Bulldog, non-Pug (2.5" bull bbl) suddenly won't release the cylinder by actuating the release latch on the frame. I can pull the extractor rod and it releases fine but using the latch alone wont push it far enough forward to release the cylinder.

    This is a one owner gun. I haven't run anything through it hotter than 13 gr of 2400 behind a 245 Keith. In fact, it dont get shot much at all, around 100 rnds a year.

    I tried to figure it out without any disassembly and came up empty. It works fine, no binding or excessive looseness (for a bulldog) but it bugs me. Any ideas?
Thread Status:
Not open for further replies.

Share This Page