ol' scratch
Member
A week ago I found out a neighbor was getting rid of some reloading supplies and an 80 percent AR jig with 2 80 percent receivers and one 0 percent. I did some horse trading and now have the whole lot. I have a custom graphics idea I am floating with the lowers. My questions are-
What are some things I should be aware of while finishing these?
Any advice concerning easier ways of doing things?
I have a drill press, a vise and a full set of tungsten carbide bits. I plan on using them to finish the 80 percent receivers. Any thoughts?
Is there a place I can send the 0 percent to have it milled so it is an 80 percent so I can finish it with my jig?
Thanks for all the advice in advance. I am kind of geeked about this. I have build all my AR's, but I have never finished an 80 percent before.
What are some things I should be aware of while finishing these?
Any advice concerning easier ways of doing things?
I have a drill press, a vise and a full set of tungsten carbide bits. I plan on using them to finish the 80 percent receivers. Any thoughts?
Is there a place I can send the 0 percent to have it milled so it is an 80 percent so I can finish it with my jig?
Thanks for all the advice in advance. I am kind of geeked about this. I have build all my AR's, but I have never finished an 80 percent before.