Trying to install new spring and buffer in a Marlin Model 9. Could not get the pin back in the front of the receiver. Jiggled it for an hour with no success. Could not make all those holes line up.
Then I discovered I had a bigger problem. The trigger and hammer are frozen. It looks to me like the hammer is at half-cock (see photo) and it's stuck (well, I can push it back and forth a bit but that's it). The trigger is also immobile.
How did I do this? Can I undo it?
Then I discovered I had a bigger problem. The trigger and hammer are frozen. It looks to me like the hammer is at half-cock (see photo) and it's stuck (well, I can push it back and forth a bit but that's it). The trigger is also immobile.
How did I do this? Can I undo it?