Bullet Sizes & Weights – How to Vary Them
--------------------------------------------------------------------------------
Quote:
The bullet diameters and weights presented in this list
are based on the use of Taracorp’s Lawrence Magnum
bullet alloy (2% tin, 6% antimony, 1/4% arsenic,
91.75% lead).
Bullet diameters and weights will vary considerably
depending on the lead casting alloy used. This variation
can be as much as 1/2% on the diameter, and 8% on
the weight among the most commonly used casting
alloys. For example, a .358-158 grain bullet might
show a diameter variation of .002", and a 13 grain difference
in weight.
Of the most commonly used alloys, wheel weights (.5%
tin, 4% antimony, 95% lead) will produce bullets having
the smallest diameter and heaviest weight, with
such bullets running approximately .3% smaller in
diameter and 3% heavier than bullets cast with
Taracorp's metal. Linotype will produce bullets with the
largest diameter and lightest weights. This alloy will
produce bullets approximately 1/10% larger and 3%
lighter than Taracorp. Other alloys of tin and antimony,
with antimony content above 5%, will produce bullets
with diameters and weights falling between those cast
from wheel weights and linotype.
Alloys containing little or no antimony will cast considerably
smaller than wheel weights and in some cases
will produce bullets too small for adequate sizing.
Within the limitations given above, the weight and
diameter of a cast bullet can be adjusted by varying the
alloy’s antimony content.
The size and weight of bullets of a given alloy will also
vary according to casting temperature. Higher temperatures
will result in greater shrinkage as the bullet
cools, thereby producing a slightly smaller and lighter
bullet than one cast of the same alloy at a lower temperature.
