Pretty new to reloading. I've been using surplus CCI primers, DP85, and pulled M25 tracers to reload Greek 30-06 for plinking loads and have been very happy with the results.
I'm looking for a similar soluntion for .308 reloads, I've got plenty of brass and primers. Anyone use DP85 in .308 at a reduced load? I believe it's got too much volumn and was considering the 4895 that GIBrass has available as the most cost effective solution, any one else have a better solution?
Any ideas for bullets? Hi-Tec has M62 tracers that are about 30% more than the M25s but they look the same, what's the difference between the them? I've started picking what I need to cast but haven't done any yet. How fast can I drive cast bullet with a gas check? I've shot some cast loads but was disappointed by the mild recoil....I'm used to a little push.
I'm looking for a similar soluntion for .308 reloads, I've got plenty of brass and primers. Anyone use DP85 in .308 at a reduced load? I believe it's got too much volumn and was considering the 4895 that GIBrass has available as the most cost effective solution, any one else have a better solution?
Any ideas for bullets? Hi-Tec has M62 tracers that are about 30% more than the M25s but they look the same, what's the difference between the them? I've started picking what I need to cast but haven't done any yet. How fast can I drive cast bullet with a gas check? I've shot some cast loads but was disappointed by the mild recoil....I'm used to a little push.
