Perhaps you all can help. I have a problem with cheek weld height on my remington LTR(leupold 3-10x40mm) and an AR varminter rifle(leupold 6.5-20x50). On both rifles my eye is just a little too low with a proper cheek weld. This makes me break the weld to bring my eye up a bit, and I believe decreases my accuracy. I have tried the delta cheek piece already and this brings my eye/cheek up way too high. Also I cannot use lower rings as my objective barely clears on the rifles.
My question is this- what do you gurus use to get some fine adjustment for your cheek weld to maintain proper eye alignment with your scope?
Thanks,
Olazul
My question is this- what do you gurus use to get some fine adjustment for your cheek weld to maintain proper eye alignment with your scope?
Thanks,
Olazul