Gordon
Member
A couple members requested pictures of my Paras. They have shot about 5k rounds between the 2 of them. The P-14 has all USGI Sear,disconnector,sear spring,hammer strut,firing pin stop, plunger and guide, thumb safety and the grip safety which I welded a hump(no body makes them for spur hammers?) and finished. The firing pin and extractor are Wilson Bullet proof and all the springs are Wolff.It has a duty 4.5 pound crisp series 80 pull!
It shoots Federal American Eagle in 2" at 25 yard off a rest! It went 1000 rounds in the AZ dust with out cleaning! I used MD X-7 lube. I am gonna keep shooting it another K or until I get a Malf!I might put a Wilson Bullet proof slide stop and a GI link in and get the
sights changed to Tritium replacements.
The P-13 is a carry/back up to the P-14. It is only 3" accurate same conditions as the P-14. It has a Wilson Bullet Proof extractor and firing pin. All springs are Wolff. It had a nice 4 pound trigger from the factory AND the sights were well regulated! This gun has never malfed in 5 years of use/carry.
These are my using/go to battle guns. I LIKE single stacks however and these Paras are butt ugly so here is an extra pic of something Good to LOOK at!
It shoots Federal American Eagle in 2" at 25 yard off a rest! It went 1000 rounds in the AZ dust with out cleaning! I used MD X-7 lube. I am gonna keep shooting it another K or until I get a Malf!I might put a Wilson Bullet proof slide stop and a GI link in and get the sights changed to Tritium replacements.
The P-13 is a carry/back up to the P-14. It is only 3" accurate same conditions as the P-14. It has a Wilson Bullet Proof extractor and firing pin. All springs are Wolff. It had a nice 4 pound trigger from the factory AND the sights were well regulated! This gun has never malfed in 5 years of use/carry.
These are my using/go to battle guns. I LIKE single stacks however and these Paras are butt ugly so here is an extra pic of something Good to LOOK
at!Attachments
Last edited:
