Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cylinder Problems

Discussion in 'Handguns: Revolvers' started by azhunter122, Aug 27, 2008.

Thread Status:
Not open for further replies.
  1. azhunter122

    azhunter122 Member

    Joined:
    Aug 16, 2008
    Messages:
    403
    Location:
    Arizona
    I recently had a snub nose revolver cylinder come out and I lost the spring before I could figure out why the cylinder fell out. I took it to the gun smith today and they wanted to send it to the factory and have me pay them to do it. I declined and deccided I don't want to send the gun to the factory at all because I know that they will charge me and my gun won't be back for months. I am going to bring it back tomorrow and see if the can get a new spring in it and find a way to put it back together. Do you think they will be able to do it? How much will it cost?
     
  2. Josh Aston

    Josh Aston Member

    Joined:
    Apr 12, 2006
    Messages:
    613
    Location:
    Mountain Home, ID
    What brand and model?
     
  3. machinisttx

    machinisttx Member

    Joined:
    Jun 5, 2008
    Messages:
    678
    Location:
    North of Dallas, south of the Red
    1. What brand of revolver
    2. What spring?
    3. How did the cylinder "fall off"?????

    go to www.brownells.com and you should be able to find replacement parts, depending on the brand of gun.
     
Thread Status:
Not open for further replies.

Share This Page