Taurus Snubbie Questions

[Sox]

I have read a mixed lot on the quality or rather lack of with these little snubs. Customer service as not being very expedient etc. Have you ever taken yours to your local smith for diagnosis/work
vs. a long wait for an incomplete, or dissatisfactory factory solution? I am at this very crossroad. I am reluctant to send it back to the factory. These are great looking guns, nicely finished, but man there is no consistency. Mine is a 731 total titanium all shadow greay beautiful. The thing is my cylinder binds a bit on two cylinders. The extractor star is clean as a whistle. The trigger is way gritty. Thanks for any input.

 

[dude]

My Taurus ti snub works just fine so I can't help you much.......but it is super easy to take the cyl and yoke out of the frame for cleaning and such. By doing this you see if the binding is an allingment problem or timing related.

 

[DeltaElite]

Honestly, I like them, but I have had bad, bad luck with the quality issues.
Others have had great luck.
Even if you have to do some work on them, they are neat guns.

I still have my eye on the Titanium Protector, when it finally arrives.

Titanium Protector

 

[dude]

I'll pick up the Taurus titanuium 9mm snub revolver once they pop up on the Market.............hopefully it will be as trouble free

 

[1badmagnum]

have your local range or dealer send the pistol into taurus.the turn around time is much quicker this way.
taurus will make it right,they just give their dealers quicker turn around.