nojoke
Member
I'd like to be able to simply swap dies from one caliber to another - I do hand gun reloading on my Hornady LnLAP.
So far I've only loaded .38sp and .357 - so I haven't had to worry about changing calibers.
I'd like to start reloading 9mm (walmart is sold out as are many retailers around here).
Is there a device for holding my decap/sizing die, my bullet feeder die, my seat/crimp die on the benchtop? I use a mix of redding and Hornady dies and for simplicity - at least for now, I'd like them on the bench sitting up.
A 2x4 with 2-1/8" holes drilled out seems kinda rough.
Suggestions?
So far I've only loaded .38sp and .357 - so I haven't had to worry about changing calibers.
I'd like to start reloading 9mm (walmart is sold out as are many retailers around here).
Is there a device for holding my decap/sizing die, my bullet feeder die, my seat/crimp die on the benchtop? I use a mix of redding and Hornady dies and for simplicity - at least for now, I'd like them on the bench sitting up.
A 2x4 with 2-1/8" holes drilled out seems kinda rough.
Suggestions?