I have several sets of Redding competition dies and since I switched over to a Forster COAX press, they no longer fit in the green boxes. MTM makes a storage box but will not accommodate the competition dies. Any suggestions?
You need to be careful using PVC. When you cut it it out gasses chlorine gas and is quite/very corrosive. I punched some holes in a pipe using a end mill and the next day the collet was rusted. Every piece of metal with end 3" of the cutter rusted. If you do use pvc make sure you coat your dies in a good inhibitor to prevent any rust.
Swipe a couple of your wife's Tupperware containers. Better yet, send her to a Tupperware party with directions to pick you up some specific sized boxes. They seal well and are stackable.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.