sugarmaker
Member
Fender washer, nut, extension screw from another double disk kit. Works reliably, no press mods. Need the riser kit installed on the DD. The washer is installed tight on the screw, use like a thumb nut and screw it into the brass nut on the measure, takes a few seconds. Adjust dillon height to lighty compress actuator bar on bottom of the beeper. After that the dillon works like normal. The top of the dillon can rotate on the die and thats how I move it in and out of position when changing expanders or adjusting powder. I prefer this to my rcbs lock out die as the lockout is much more disruptive to the load sequence when being adjusted etc. sorry the image is sideways but you get the idea... Its very simple.
