hokeyplyr48
Member
First of all, my brass prep method is as follows:
1. Deprime (universal decapper)
1a. If brass is really dirty/sooty, rinse with soap/water to not kill my media
1b. Tumble
2 Inspect
3 lube brass
4 resize/prime
5 tumble again to remove lube/polish mirror shine
Is this process ok? Will the corn cob media (20/40 grit) in the second tumbling get stuck on anything inside the case? Like the flash hole?
Second, will using 20/40 grit clean the primer pocket? I know it doesn't get stuck, but does that mean it will clean/polish it?
1. Deprime (universal decapper)
1a. If brass is really dirty/sooty, rinse with soap/water to not kill my media
1b. Tumble
2 Inspect
3 lube brass
4 resize/prime
5 tumble again to remove lube/polish mirror shine
Is this process ok? Will the corn cob media (20/40 grit) in the second tumbling get stuck on anything inside the case? Like the flash hole?
Second, will using 20/40 grit clean the primer pocket? I know it doesn't get stuck, but does that mean it will clean/polish it?