Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Early model Charter Undercover Question

Discussion in 'Handguns: Revolvers' started by crawdad185, Dec 30, 2012.

Thread Status:
Not open for further replies.
  1. crawdad185

    crawdad185 Member

    Joined:
    Dec 30, 2012
    Messages:
    10
    Location:
    GA
    Hi folks. I've got an early model charter undercover that my uncle gave me for a pocket pistol. The cylinder latch was bad so I got new parts and replaced that. I went out to shoot it today and, although it shoots fine, I noticed that when I swing the cylinder out and fully load it, the cylinder want spin around. If it is unloaded, it spins fine. It appears the edge of the bullet casing is hitting on the cylinder stop screw (the small screw that keeps the cylinder from going back too far). Does anyone have any experience with the charters who can tell me if this is normal or if I have another problem?
    Thanks for your help.
     
  2. lowercase

    lowercase Member

    Joined:
    Aug 6, 2008
    Messages:
    393
    Location:
    Pacific Northwest
    It's normal. Mine all do that.
     
  3. Kymasabe

    Kymasabe Member

    Joined:
    May 28, 2006
    Messages:
    833
    Location:
    Northern by birth, Southern by choice.
    Mine do that too.
     
  4. crawdad185

    crawdad185 Member

    Joined:
    Dec 30, 2012
    Messages:
    10
    Location:
    GA
    Ok, good to know. Thanks for your help.
     
Thread Status:
Not open for further replies.

Share This Page