• You are using the old Black Responsive theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.

expander ball size for my Mosin Nagant?

Status
Not open for further replies.

usmc0811

Member
Joined
Nov 7, 2010
Messages
178
Location
Pennsylvania
I have a Mosin Nagant that I would like to reload cast bullets for. My bore was slugged to .313"
My current Lee die set has an expanding ball that I measured out to be .308"
I was planning on casting bullets sized to .314" as that would make my bullets 1,000th larger to my bore. My question would be what size expander should I get to replace my current one of .308" or am I good with that?
 
When I bought my Lee 7.62x54r die it had a .308 expanding ball in it. My rifle needs a .312 round so I called Lee & they sent me the .312 expanding ball free. I don't know where you are going to find an expanding ball that big, you may have to have one custom made.
 
I have a Mosin Nagant that I would like to reload cast bullets for. My bore was slugged to .313"
My current Lee die set has an expanding ball that I measured out to be .308"
I was planning on casting bullets sized to .314" as that would make my bullets 1,000th larger to my bore. My question would be what size expander should I get to replace my current one of .308" or am I good with that?
Buy one for a 8x57 or 32 special.
Chuck it in a drill and turn it down with sandpaper.
As a side note. Make sure your chamber has clearance for a .314 bullet and the case neck. You may need to neck turn brass.
 
As a side note. Make sure your chamber has clearance for a .314 bullet and the case neck. You may need to neck turn brass.

Agreed. I didn't run in to problems until I started trying to chamber .316 bullets, but if you have exceptionally thick-necked brass (Talking to you, Winchester) you may have to turn necks at .314.

Depends on the rifle/chamber.
 
Status
Not open for further replies.
Back
Top