danosrs
Member
I have a P9R that has trouble extracting the shell, when it jams the empty shell is still part way in the barrel.
I have removed the extractor, roll pin and spring and assurred they were clean and checked the tip that touches the shell and does not look to have any chips or damage.
This gun was purchased in 93 and fired several hundred rounds without problems, but lately its bad. Tried several different ammo (CCI, UMC, Winchester) and only the UMC worked Ok with two FTE.
I guess I will try to find a place to order a new extractor and spring since it seems to have trouble holding the shell when the bolt goes back, also it will cycle all ammo thru when I do by hand, never has a problem when I do that.
Any suggestions on what to try or maybe some info on where to buy parts??
anyone else have this problem? are these guns not reliable? If I can not fix by changing parts would this gun be worth sending to a gunsmith to be fixed?
I have removed the extractor, roll pin and spring and assurred they were clean and checked the tip that touches the shell and does not look to have any chips or damage.
This gun was purchased in 93 and fired several hundred rounds without problems, but lately its bad. Tried several different ammo (CCI, UMC, Winchester) and only the UMC worked Ok with two FTE.
I guess I will try to find a place to order a new extractor and spring since it seems to have trouble holding the shell when the bolt goes back, also it will cycle all ammo thru when I do by hand, never has a problem when I do that.
Any suggestions on what to try or maybe some info on where to buy parts??
anyone else have this problem? are these guns not reliable? If I can not fix by changing parts would this gun be worth sending to a gunsmith to be fixed?