callenlee
Member
Hi everyone, I'm building my first AR and have everything together on the lower receiver. It is an Aero Precision lower with PSA MOE parts kit and a UTG buffer and stock. Everything went together pretty smoothly. The only issue was the hole for the selector detent was too tight, but I got that worked out.
Because this is my first build and my first AR I did have a quick question. The hammer is putting tension on the bolt release so that the release will stay up if the button is pushed. I'm not too concerned about it because I realize the hammer will be back whenever the bolt release needs to be released. Am I right in not worrying about this or is it something I should look into remedying?
Because this is my first build and my first AR I did have a quick question. The hammer is putting tension on the bolt release so that the release will stay up if the button is pushed. I'm not too concerned about it because I realize the hammer will be back whenever the bolt release needs to be released. Am I right in not worrying about this or is it something I should look into remedying?