My terminology error! I did mean the expander die. It didn't feel right to twist an extra 1/4 after plate contact. I guess that's the error. I think I left it at contact or even slightly backed out!
Mt FCD is making contact with finished round ejector just at the edge, so I can't adjust it down to plate contact. Should this matter as long as the crimp adjustment is set properly? Or does the FCD need to set all the way down to get the proper taper?
Mt FCD is making contact with finished round ejector just at the edge, so I can't adjust it down to plate contact. Should this matter as long as the crimp adjustment is set properly? Or does the FCD need to set all the way down to get the proper taper?