Olympus
Member
- Joined
- Jul 14, 2008
- Messages
- 4,212
I just got done with my first batch ever of 50 rounds of 9mm on my Load Master. I used 3.2g of HP-38 with a 125 grain Missouri Bullet. Had a few questions.
1. Question about overall length. It seems that my rounds vary from 1.067 to 1.082. I'm trying to get the OAL at 1.07. I'm using the bullet seat die and factory crimp die seperate. Is there a reason for this? Is this something that is going to cause a problem?
2. Every few rounds, a primer will not be sitting flush in the head of round. About 4 out of 5 primers will be sitting flush, but 1 out of 5 will be very slighly raised above the surface. Is there a reason for this? Is this going to cause problems?
1. Question about overall length. It seems that my rounds vary from 1.067 to 1.082. I'm trying to get the OAL at 1.07. I'm using the bullet seat die and factory crimp die seperate. Is there a reason for this? Is this something that is going to cause a problem?
2. Every few rounds, a primer will not be sitting flush in the head of round. About 4 out of 5 primers will be sitting flush, but 1 out of 5 will be very slighly raised above the surface. Is there a reason for this? Is this going to cause problems?