Joe Link
Member
Here was my original issue:
So I got it back from the factory today and the test target (shot after they replaced the barrel) looks like:
Now, I understand that it was at 25 yards, but shouldn't it be shooting groups closer to the center of the target? What would cause the group to be so low and to the right? I sent it back because it wasn't shooting straight and from the looks of this target, it still isn't. Now, I also noticed on the paperwork it says:
Their troubleshooting is confusing me. If the gun was shooting off center and they found a problem with the barrel, wouldn't they replace the sight and sight it in before range testing it to make sure it was the barrel? How would they know it was the barrel unless the sights were properly adjusted? Can someone please explain this to me? I plan on calling them on Monday, but I'm really curious
Roughly two years ago my girlfriend bought me my first (and only) 1911, a beautiful Springfield Loaded with factory night sights and CT grips. I couldn't wait to get it to the range, but once there I was highly disappointed. The CT grips were off by quite a bit, which was fine because I can adjust them easily myself. However, when I tried the sights, the gun consistently shot high left, about 2-3" up and 2-3" over, and I was shooting from the bench. I figured it was probably me because I was still getting used to the gun.
On my next visit there was a guy there with a GI model shooting one rough hole. We got to talking and I told him my problem, then asked him to try shooting my 1911. Shooting it from the bench, he was able to shoot one hole with it as well, but it was off the same as when I shot it, 2-3" high, 2-3" to the left. We drifted the rear sight a bit and got it down to about .75" to the left, but the sight was all the way over and the gun was still shooting high. Since that range visit the gun has been in my safe, untouched. I really like 1911's and I think it's time to get this problem corrected so I can shoot it.
I know Springfield has a warranty, but would it cover something like this? If not, how much would it cost to have them dial it in? Would it be better to take it to a local gunsmith? How much should I expect to pay?
So I got it back from the factory today and the test target (shot after they replaced the barrel) looks like:
Now, I understand that it was at 25 yards, but shouldn't it be shooting groups closer to the center of the target? What would cause the group to be so low and to the right? I sent it back because it wasn't shooting straight and from the looks of this target, it still isn't. Now, I also noticed on the paperwork it says:
Repair 1911 Pistol
1 - 1911 .45 Barrel, SS
Range Tested - Sending Target
1 - .160 Dovetail Frt Night Sight
Note: Front Sight Was Installed After Target
Their troubleshooting is confusing me. If the gun was shooting off center and they found a problem with the barrel, wouldn't they replace the sight and sight it in before range testing it to make sure it was the barrel? How would they know it was the barrel unless the sights were properly adjusted? Can someone please explain this to me? I plan on calling them on Monday, but I'm really curious