Hi all.
Just bought a used GP100 4" SS. Made in Jan 2012.
Questions I have for you revolver guys is a new SP101 or GP100 the inside and outside edges of the forcing cone are pretty sharp. The gun i bought needed to be cleaned up and the front of the cylinder had some rings on it that i removed, The inside edges of the forcing cone are smoothing out, ever so slightly rounded(I would not say the wear was excessive) Just wondering about how many rounds would it take to start smoothing that edge of the forcing cone? Hope this question makes sense..
Thanks all
Just bought a used GP100 4" SS. Made in Jan 2012.
Questions I have for you revolver guys is a new SP101 or GP100 the inside and outside edges of the forcing cone are pretty sharp. The gun i bought needed to be cleaned up and the front of the cylinder had some rings on it that i removed, The inside edges of the forcing cone are smoothing out, ever so slightly rounded(I would not say the wear was excessive) Just wondering about how many rounds would it take to start smoothing that edge of the forcing cone? Hope this question makes sense..
Thanks all