crawdaddy
Member
I'm looking for a set of rubber grips that will fit a H&R Model 904. I was hoping to find something that would work, even if it was from a different make/model. Any suggestions?
Grips for H&R .22
- Thread starter crawdaddy
- Start date
- Status
gb6491
Member
I'd be tempted to try the ones on the Numrich site listed as "Style B - Square-butt fits all NEF square-butt revolvers as well as H&R models 732, 733, 929, 930, 922, 923, 926 and 939."
Though the 904 is not listed here's a photo comparison of one and a 929 (which is listed):
Regards,
Greg
Though the 904 is not listed here's a photo comparison of one and a 929 (which is listed):
Regards,
Greg
crawdaddy
Member
does anybody know if there is a S&W or Taurus with grips that would fit the H&R 904? Or maybe a Rossi or Charter... just something not discontinued.
Is your gun a square butt? I have an old H&R .22 revolver, but I'm not well-versed in the things.
The frame is still being used to make higher-end starter pistols, though it's a round butt.
Check these guys out: http://www.weaponsofchoicetheatrical.com/ They do all sorts of grips to give the guns different appearances for stage use.
Also look for the things through gun dog training supply houses.
Your choices will be limited.
Why rubber?
The frame is still being used to make higher-end starter pistols, though it's a round butt.
Check these guys out: http://www.weaponsofchoicetheatrical.com/ They do all sorts of grips to give the guns different appearances for stage use.
Also look for the things through gun dog training supply houses.
Your choices will be limited.
Why rubber?
- Status
