I may have found a problem with the H&K 2000 pistols. I would to know if anyone else has had a similar problem?
I qualified with my issue H&K 2000 today. Afterwards, when I cleaned it, I could not reassemble the pistol. The slide would not go all the way onto the frame.
I eventually found that a small roll pin, just above the hammer retaining pin would slide out to the left side if I dry fired the pistol without the slide being attached.
It took a small mallet to drive the pin back in. It is the larger of two pins ahead of the hammer and above the hammer retaining pin.
Has anyone else had a problem like this with an H&K 2000 or USP?
Jim
I qualified with my issue H&K 2000 today. Afterwards, when I cleaned it, I could not reassemble the pistol. The slide would not go all the way onto the frame.
I eventually found that a small roll pin, just above the hammer retaining pin would slide out to the left side if I dry fired the pistol without the slide being attached.
It took a small mallet to drive the pin back in. It is the larger of two pins ahead of the hammer and above the hammer retaining pin.
Has anyone else had a problem like this with an H&K 2000 or USP?
Jim