david_the_greek
Member
- Joined
- Nov 2, 2005
- Messages
- 533
Hi everyone, I have recently been asked by my uncle to clean up and attempt to fix a problem with a Harrington and Richardson Arms Co. 38 S&W CTGE revolver. This revolver is chromed I believe and not stainless, please correct me if I am wrong as I know nothing about this revolver. The problem with the revolver is that the trigger will not reset. It is a double action revolver that resets itself after each pull of the trigger and this particular handgun the trigger will pull but it remains at the rear of the trigger guard, inhibiting further firing. I can manually pull the trigger forward to reset the firearm. I took the revolver apart to its basic components but am still unsure what was the cause of this problem. I have not had too much time to check this out but am not sure where to start at I suppose. Anyone know of any good websites with info on take down and repair? Also what would be good to take off the surface rust that is on the pistol? Thanks I'll try to keep everyone updated on what I am doing.