Coyote3855
Member
Some years ago I acquired a .38 caliber Colt revolver with a 2-inch barrel. Markings on the left side of the barrel are a large 38 with the words OFFICIAL POLICE in two lines. On the right side of barrel also in two lines: COLT’S PTFA MFG CO, HARTFORD, CONN USA. Both sets of markings are centered lengthwise on the barrel.
There are no other markings on the exterior of the revolver except the rampant Colt on the left side of the frame. All markings are crisp and clear with no indication that the gun has been buffed or refinished.
The revolver appears to be silver plated rather than nickeled or chromed because the finish tarnishes. The trigger, back strap, cylinder latch knob, and rear of the hammer spur are finely checkered.
The rear sight is dovetailed into the top of the frame and is adjustable for windage. There is a small screw through the top of the sight which holds the sight in the dovetail, and a screw in the side of the frame that appears to be used to adjust the sight. The top of the frame in front of the sight has five fine lines parallel to the bore about ¼ inch long. The center of the sight has a single inscribed line extending forward to align with the lines on the frame. The top of the frame is flat from the front sight to the point it tapers down to the barrel.
The grips are wood checkered with Colt medallions and are probably a recent replacement. I believe the originals would have been black hard rubber.
The serial number is 382XXX with a capital “N” under the first digits of serial number. The serial number appears on the crane and on the frame opposite the crane.
The serial number is lower than the 513216 where Proofhouse.com shows the Official Police Series began in 1927 as a continuation of the Army Special.
So what is this thing? I know about Colt letters, but I’m reluctant to spend more on the letter than I did on the gun.
There are no other markings on the exterior of the revolver except the rampant Colt on the left side of the frame. All markings are crisp and clear with no indication that the gun has been buffed or refinished.
The revolver appears to be silver plated rather than nickeled or chromed because the finish tarnishes. The trigger, back strap, cylinder latch knob, and rear of the hammer spur are finely checkered.
The rear sight is dovetailed into the top of the frame and is adjustable for windage. There is a small screw through the top of the sight which holds the sight in the dovetail, and a screw in the side of the frame that appears to be used to adjust the sight. The top of the frame in front of the sight has five fine lines parallel to the bore about ¼ inch long. The center of the sight has a single inscribed line extending forward to align with the lines on the frame. The top of the frame is flat from the front sight to the point it tapers down to the barrel.
The grips are wood checkered with Colt medallions and are probably a recent replacement. I believe the originals would have been black hard rubber.
The serial number is 382XXX with a capital “N” under the first digits of serial number. The serial number appears on the crane and on the frame opposite the crane.
The serial number is lower than the 513216 where Proofhouse.com shows the Official Police Series began in 1927 as a continuation of the Army Special.
So what is this thing? I know about Colt letters, but I’m reluctant to spend more on the letter than I did on the gun.