Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

help removing ak mojo peep sight

Discussion in 'Rifle Country' started by Jrob24, Dec 10, 2009.

Thread Status:
Not open for further replies.
  1. Jrob24

    Jrob24 Member

    Joined:
    Dec 30, 2002
    Messages:
    434
    Location:
    taxachusetts
    I just purchased and installed a tech sight for my WASR10 and it looks great. My problem is removing the old rear sight. Help please? BTW I don't have a vice.



    [​IMG]
     

    Attached Files:

  2. AK103K

    AK103K Member

    Joined:
    Dec 27, 2002
    Messages:
    5,774
    The way I get the AK rear sights out, is to put the rifle across the corner of my workbench, resting at the flat of the mag well. Take a flat blade screw driver, with a piece of tape on the tip, put it in the notch in the center of the sight, at the end where it connects to the gun, and push down and towards the rear of the gun. The sight should pop right out. It will take a little pressure, but be ready for it when it goes and watch you dont stab yourself with the screw driver.

    I've also heard some say they use a rod in a drill press, and using the rod, depress the spring under the end of the sight, and then remove the sight while the pressure is off.

    I dont have a drill press. :)
     
  3. Jrob24

    Jrob24 Member

    Joined:
    Dec 30, 2002
    Messages:
    434
    Location:
    taxachusetts
    Thanks I got it done :D
    That took a fricken lot of force :eek:

    The sight picture looks great now. All that's left is zeroing it.

    [​IMG]

    [​IMG]
     

    Attached Files:

  4. AK103K

    AK103K Member

    Joined:
    Dec 27, 2002
    Messages:
    5,774
    Cool. Looks good. Let us know how it shoots. :)
     
Thread Status:
Not open for further replies.

Share This Page