I made 200 38 Special cartridges with bullets from “Blue Bullets” I also made some with SWC bullets I casted.
I realized after reloading I over loaded them. So much they were over and maximum safe load.
I have a RCBS bullet puller and a Franklin inertia puller.
The cast SWC I made came out easy. But the Blue Bullets are almost impossible to get out. I assume that the coating on the bullet is seating it very tightly.
Does anyone have an idea on how to loosen the bullet. The inertia puller will not budge the bullet even after 30 hits.
Would putting then in sub boiling water for a few minutes help? I really do not want to lose the bullet, case and primer.
Does anyone have an idea? What do you think of the hot water idea?
I realized after reloading I over loaded them. So much they were over and maximum safe load.
I have a RCBS bullet puller and a Franklin inertia puller.
The cast SWC I made came out easy. But the Blue Bullets are almost impossible to get out. I assume that the coating on the bullet is seating it very tightly.
Does anyone have an idea on how to loosen the bullet. The inertia puller will not budge the bullet even after 30 hits.
Would putting then in sub boiling water for a few minutes help? I really do not want to lose the bullet, case and primer.
Does anyone have an idea? What do you think of the hot water idea?