Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hennings's grips for Witness elite match

Discussion in 'Handguns: Revolvers' started by greyling22, Sep 25, 2010.

Thread Status:
Not open for further replies.
  1. greyling22

    greyling22 Member

    Joined:
    Aug 6, 2007
    Messages:
    4,429
    Location:
    East Texas
    I searched all over the internet and couldn't come up with any pictures of Hennings's grips on a gun, But I bought them anyway and now I am posting the pictures. The regular grip width measured out 1.35 inches, and Henning's grips reduced it to 1.2 inches. They fit on nice and tight and the thinner grip is super, I just wish they were longer. they expose some nooks and crannies the factory grips covered up. I also with they were made of plastic and cost $40. But all in all, I'm pleased, and if you can get ahold of henning he's great to talk to.

    PS: you need to buy the Henning's torx screws. the factory screw heads are too big for Hennings's holes. Or you can try turning your heads down or going to the hardware store.
     
    Last edited: Sep 25, 2010
  2. greyling22

    greyling22 Member

    Joined:
    Aug 6, 2007
    Messages:
    4,429
    Location:
    East Texas
    Mods, I realized I put this in the wrong forum. could it be moved to autoloaders?
     
Thread Status:
Not open for further replies.

Share This Page