Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Heritage Rough Rider 45 Colt Barrel Problem

Discussion in 'Handguns: Revolvers' started by Ed Gallop, Sep 17, 2007.

Thread Status:
Not open for further replies.
  1. Ed Gallop

    Ed Gallop Member

    Joined:
    Jan 8, 2007
    Messages:
    177
    Location:
    Stuart, VA
    I bought a 45 Colt Rough Rider Big Bore and it was sent to me with the barrel in the frame so far that the cylinder would rub on it instead of spinning on the hub.

    Heritage sent me a new one and I liked it very much. It was smooth and accurate. I loaded 5.5 gr (7cc) of Unique behind a 255 gr SWC cast bullet and I could group tight on sight at 35 feet. After shooting about 50 rounds it now shoots about 3" to the left in the same tight group. Apparently the barrel is twisting, even with this fairly light load. I'm afraid the barrel will continue to twist and end up like the first one if tightened. It may be that all the Heritage Big Bore revolvers have soft frames.

    Has anyone else had this trouble with their Heritage Big Bore? Ed.
     
  2. Ed Gallop

    Ed Gallop Member

    Joined:
    Jan 8, 2007
    Messages:
    177
    Location:
    Stuart, VA
    Apparently this is an unusual incident. I found Heritage to be very easy to communicate with and their customer service is great. If you have a problem revolver they will replace it without hesitation and almost overnight. They fixed the problem. Ed.
     
Thread Status:
Not open for further replies.

Share This Page