Hi Point 9mm Carbine

[CornCod]

The whole assembly that holds the front sight on the barrel of my Hi-point Carbine has become loose. There is a strange kind of screw on that underside of it that tightens it to the barrell. What is the name of the tool that is used to tighten it?

Thank You!

 

[SigfanUSAF]

A pic, if you will.

 

[karlsgunbunker]

probably an Allen Wrench. You should have received a couple of allen wrenches and a flat wrench with two hex shaped holes a screw driver on one end and a tool to release the trigger lock on the other. These tools are all you need to disassemble or adjust the rifle

 

[CornCod]

Thanks

Thanks gentlemen! Sometimes being a gun owner and non-mechaincal can be a trial. Same thing with my other hobby, motorcycling.

 

[OK-gobbler]

Same thing happened to mine. Allen wrench tightened it up and worked fine. Good Luck

 

[wolf_from_wv]

995 Carbine
* Stock: 1/8" allen wrench
* the screw in front of the trigger guard: 3/32" allen wrench
* front sight set screws: 5/64" allen wrench
* front sight bolt: 1/4" ?
* rear sight screws: 3/32” allen wrench
* 1/4” wrench
* 5/16” wrench (2)
* 7/16” wrench
* 1/16” pin punch
* 3/32” pin punch
* 1/8” pin punch
* semi-large non-marring punch
* Ball pein hammer
* Hockey pucks for bench blocks