stubbicatt
Member
Tom Unler, I have found that CCI standard velocity rounds work pretty well, though I understand there are others that work better.
The way I clean mine is to remove the barrel, pull the slide off, wipe down the slide and mating surfaces on the frame, clean the barrel with whatever solvent you like, a couple drops of oil on each of the slide rails, and reassemble. I have never experienced leading with these pistols and any ammunition I have used. I have not used a bronze brush, but depending on the condition of the area ahead of the chamber I will sometimes run a nylon bore brush in there and spin it around a few times to remove buildup in the leade area.
Hope this helps.
The way I clean mine is to remove the barrel, pull the slide off, wipe down the slide and mating surfaces on the frame, clean the barrel with whatever solvent you like, a couple drops of oil on each of the slide rails, and reassemble. I have never experienced leading with these pistols and any ammunition I have used. I have not used a bronze brush, but depending on the condition of the area ahead of the chamber I will sometimes run a nylon bore brush in there and spin it around a few times to remove buildup in the leade area.
Hope this helps.
Last edited: